Welcome to Sophenol

Mode Conditioning Cable 2xFC 62.5/125 to 1xFC 9/125 & 1xFC 62.5/125

Please Contact Us for Your Various Requirements on Fiber Optic.

Mode Conditioning Cable 2xFC 62.5/125 to 1xFC 9/125 & 1xFC 62.5/125

Mode conditioning fiber optic patch cables are used specifically in Gigabit Ethernet 1000BASE-LX/LH applications where the objective is deploying new high-speed 1000BASE-LX routers, switches, or transceivers within existing multimode system backbones.Mode conditioning fiber jumpers are used in the 1300nm or 1310nm optical wavelength window, and should not be used for 850nm short wavelength window such as 1000Base-SX. Also, any attempt to connect 1000Base-LX/LH equipment over short distances of multimode fiber without the use of mode conditioning fiber will result in a high bit error rate, and eventually damage to the device.

Features:

  • Compliant with IEEE 802.3z
  • To replace the standard equipment-to-cable plant patch cable
  • Rugged Offset Closure with Consistent Offset


Applications:

  • To replace the standard equipment-to-cable plant patch cable
  • Gigabit Ethernet 1000Base-LX (1300nm wavelength)
  • LX Gigabit Systems

Why do you need a mode conditioning cable?

  • You want to use Gigabit 1000Base-LX equipment with your existing multimode cable plant.
  • 1000BASE-LX is specified to work over a distance of up to 5km over single-mode fiber. But 1000BASE-LX can also run over multi-mode fiber with a maximum segment length of 550m.
  • For any link distance greater than 300 m, the use of a special launch mode conditioning fiber patch cable may be required.


 How does mode conditioning cable work?

Mode conditioning cable launches the laser at a precise offset from the center of the multimode fiber. This causes the laser to spread across the diameter of the fiber core, reducing the effect known as differential mode delay which occurs when the laser couples onto only a small number of available modes in multi-mode fiber.